|
|
|
|
|
|
|
|
 |
Please click image to order a catalogue. |
|
Clamping
Elements RCK 70
|
|
 |
These
shaft clamping elements are designed to give optimum concentricity, both
radically and axially. Similar in design to the RCK 13, but with increased
length to provide improved support, and reduced pressures on both shaft
and hub. These units must always be installed inside the hub to ensure optimum
concentricity. Axial movement of hub will occur during clamping operation. Clamping Elements RCK 70 PDF Catalogue |
 |
|
| Clamping
Elements RCK 71 The RCK 71 is a type RCK 70 with addition of a distance ring to prevent axial movement of the hub during clamping. Due to the additional friction between the element and hub during clamping maximum torques are reduced, but with reduction in surface pressures also. This design can be mounted within the confines of a hub providing a stepped bore is provided to accommodate the flange. Clamping Elements RCK 71 PDF Catalogue |
 |
|
|
|
Clamping
Elements RCK 80
|
|
 |
Available
for shaft diameters down to 6mm, these shaft clamping elements are designed
to fit into small diameter hubs, being particularly suited to light duty,
light torque applications. A spacer ring prevents axial movement during
cramping; and design ensures good levels of concentricity. For correct operation
of these units, the hub diameter should not be less than the flange diameter
, even though with many materials stress limits would allow selection of
smaller hub diameters. Clamping Elements RCK 80 PDF Catalogue |
|
|
| Clamping
Elements RCK 95 Similar in design to the Clamping Discs, type RCK 19, but with the discs spaced further apart to enable connection to more than one shaft, enabling use as a rigid shaft coupling. These units can be used to connect two identical diameter shafts which are perfectly aligned, or to produce a longer shaft which is only mounted in two bearings. Torque capacities are suitable for standard shafting. These units provide zero backlash shaft connection with advantage of fast assembly and disassembly. The design makes the unit equally suitable for horizontal and vertical shafts, capable of withstanding high axial loads. Clamping Elements RCK 95 PDF Catalogue |
 |
|
|